PROBLEMS WITH XTC MODE

An area for people to discuss Scope related problems, issues, etc.

Moderators: valis, garyb

Post Reply
Djfoka
Posts: 4
Joined: Sun Nov 17, 2002 4:00 pm

Post by Djfoka »

Hi there!!!
I bought Powersampler card and after i update the software to Luna 2.5, after i bought the Luna 3 software and after some days ScopeFusion was out and i install it on my PC.

Im using a Pc:
Windows 2k with service pack 3
Pentium III 733 with 512 Mb ram
Cubase SX

The problem is that when i start the XTC mode and turn off SFP in Cubase Sx ther's no sound card available.
Can anyone explain me how can i use XTC mode with SX?
Do i need another sound card to audio output?
Is it possible to use XTC mode with my card only?
With my card witch is the best way to get best features? i don't need a sampler i need a good audio output and if possible use dsp effects on my produtions.
Please help this is really impotant cos i've been spending some money on creamware stuff but so far i'm not getting what i need from it, it was nice if i can use all features available.
Top
Tomhawk
Posts: 7
Joined: Sun Jun 30, 2002 4:00 pm

Post by Tomhawk »

High there!

I have the same issue and really dont see the point in having to use another soundcard to use XTC mode!!!

The advise i got was to turn off SFP before starting but then: Asio Driver error etc cause there is no drivers to feed SX.

In the manual (Pulsar) it is "important" that the Creamware Platform opens before any applications so this doesnt sound equal.

I am trying to get an answer from the company that sold me the card and i will get back with
some news about the issue i hope!

Best Regards

Tomhawk!
Top
User avatar
at0m
Posts: 4743
Joined: Sat Jun 30, 2001 4:00 pm
Location: Bubble Metropolis
Contact:
Contact at0m

Post by at0m »

SFP -> Set -> Settings -> Global -> XTC -> (x) Enable XTC mode

Make sure XTC devices are installed with SFP setup.
Top
camed
Posts: 16
Joined: Sun Dec 08, 2002 4:00 pm
Location: London

Post by camed »

Another idea: did you use IOEnabler.exe? It may be necessary to run it..
Just my 2 cents, I'm a complete beginner with sfp!
Top
stelibo
Posts: 57
Joined: Fri Dec 06, 2002 4:00 pm
Location: Macedonia
Contact:
Contact stelibo

Post by stelibo »

On 2002-12-12 20:27, at0mic wrote:
SFP -> Set -> Settings -> Global -> XTC -> (x) Enable XTC mode

Make sure XTC devices are installed with SFP setup.
Does it mean that XTC mode will work with SX and opened SFP?
I think (I will check now) that XTC mode dont work with SFP and SX until SFP is closed and then restart SX. It should be OK now.
Regards,
Bobi & KOMPAS band
BLUE production
Top
Post Reply

Return to “Problem Solving”