Maybe more a question for the Cubase Forum but....

djevo · Post by **djevo** » Thu May 09, 2002 10:50 am

but... you guys helped me out sveral times so I'll try it.

The Reason Cubase Pulsar setup is OK, but I don't understand the following.

Reason is connected via Rewire to Cubase so when I look in the channelmixer I see the drumcomputer connected to channel 3 and 4 appering on channel 3 and four. Same for the drumcomputer connected to channel 5 and 6; it appears in the channel mixer on channel 5 and 6.

But when I record in cubase audio track 1 it records both drumcomputers at the same time on that track. Is it possible to route drumcomputer 1 to audio track 1 and drumcomputer 2 to audiotrack 2?

Also, the whole Reason package is on Asiochannel (in Pulsar) 1 (left) and 2 (right). Is this correct?

I know I've asked questions which looks like this one but it's obviuos I'm still struggling with this.

1 other question... why is the signal output (to my receiver I mean) from Pulsar not so loud?

Hope somebody knows.....

[ This Message was edited by: djevo on 2002-05-09 11:53 ]

at0m · Post by **at0m** » Thu May 09, 2002 11:42 am

-> For recording: is your multi track recording enabled, do you record straight from Reason or do you record ASIO from your Project?

-> Reason on one stereo ASIO pair: Reason goes to ASIO via Cubase, check Cubase's setup. Activate more mastering busses or just assign Reason channels to different Mastermixer ports.

djevo · Post by **djevo** » Thu May 09, 2002 12:43 pm

On 2002-05-09 12:42, at0mic wrote:
-> For recording: is your multi track recording enabled, do you record straight from Reason or do you record ASIO from your Project?

Hi at0mic....again

when I enable multrirecord and this is set to "merge" I can record but there's no signal. To be honest I don't know where I record from...

-> Reason on one stereo ASIO pair: Reason goes to ASIO via Cubase, check Cubase's setup. Activate more mastering busses or just assign Reason channels to different Mastermixer ports.

mastering busses? activate them? assigning Reason channels? pff, sounds difficult to me

and the cubase manual definitely does NOT help

Sorry if I sound a little bit frustrated but in fact I am...

But, at0mic, I have to thank you so far again! Thanks!

[ This Message was edited by: djevo on 2002-05-09 13:44 ]

at0m · Post by **at0m** » Thu May 09, 2002 2:43 pm

djevo wrote: mastering busses? activate them? assigning Reason channels? pff, sounds difficult to me

Double click ASIO Source in SFP. Make it 8, so you have 4 Stereo ASIO busses.
Go to Cubase, hit Ctl-+ for MasterMixer.
Activate the other 3 busses. Now Cubase can send to the 4 stereo busses from SFP. Hit Ctl-*, for VST mixer. Select desired bus below on each Rewire channel.

Concerning recording Rewire instruments: I normally record back from Pulsar OS, what I've mixed and processed there. If you want to do it inside Cubase/Reason, choose MixDown on MasterMixer. Solo the Rewire tracks you want to record. You'll get one stereo file I think.

Tot de volgende,

at0mic.

_________________
Ever been at http://www.dourfestival.be ?

[ This Message was edited by: at0mic on 2002-05-09 15:43 ]