Luna "wiring" problem

MrV · Post by **MrV** » Tue Oct 05, 2004 10:56 am

Hello ,
Has anyone had this problem ?
I've built a portable recording system ...a P4 2.6G in a small footprint "MiniQ" case ...has 1 pci slot for a Luna card with additional adat backplate . All working great except when I reload an existing project some of the audio wiring in the project window is incomplete...for example,1632mixer aux1 and 2 to luna adat dest 1 and 2 is not connected ...it was before I saved project ...or masterverb is not connected to 1632 Rt1 L/R when it was before , etc . I've tried re-installing Luna/Scope software , hasn't helped .
Very weird .
Any ideas folks?
Regards,
Michael

Counterparts · Post by **Counterparts** » Tue Oct 05, 2004 10:59 am

It's a UI issue, not a wiring one

Check to see what the Live Bar is reporting with respect to the connections. The Masterverb always appears to be disconnected when in fact it is still wired up OK.

Royston

Post by **Guest** » Tue Oct 05, 2004 3:03 pm

try rebuiding the project new and see.

MrV · Post by **MrV** » Tue Oct 05, 2004 7:47 pm

Thanks guys .
Counterparts... I'll often get,for example, Masterverb just with one output wired instead of the 2 outputs....and the unwired return really is unwired, signal from the other side only. Don't use Live Bar , maybe I should have a look at that as you suggest .Cheers, M