MIDI Controllers - I give up

Ganool · Post by **Ganool** » Sat Aug 31, 2002 2:04 pm

How do I assign MIDI Controllers in v3 devices? In old devices it's very easy (you re-save the entire device).

This is how I've done: Load MINIMAX, assign the right controllers, save a preset in the MIDI Controller Preset-List.

Guess what happens if I reload the device and double-click on my midi controller? SPF crashes.

Any ideas?

Carl.

Ganool · Post by **Ganool** » Sat Aug 31, 2002 4:09 pm

...now I've been doing some tests.

Minimax - crashes.
Inferno - works fine.
Blue Synth - remembers the first controller only.

Fantastic. Isn't it?

Is there any way to make the controllers autoload as well?

Ganool · Post by **Ganool** » Sun Sep 01, 2002 2:09 am

Bump.

Come on... are there really none of you that use MIDI Controllers????

Nikibuzz · Post by **Nikibuzz** » Sun Sep 01, 2002 2:18 pm

When you save the controler settings make sure you save them in the midi preset section.

The preset section doees not always remember controler information

Ganool · Post by **Ganool** » Sun Sep 01, 2002 3:01 pm

On 2002-09-01 15:18, Nikibuzz wrote:
When you save the controler settings make sure you save them in the midi preset section.

The preset section doees not always remember controler information

Yeah. I did that.
You know about any way to make the controllers autoload?

Carl.

Nikibuzz · Post by **Nikibuzz** » Mon Sep 02, 2002 4:39 am

No I don't.
I'm sorry but I use controllers for everything from automated mix downs to sampler parameters and I have no problems with SFP.
But let me say I still run on WIN 98.
It's still the most stable

at0m · Post by **at0m** » Mon Sep 02, 2002 10:10 am

the CC# preset is stored with the project.

<font size=-1>[ This Message was edited by: at0mic on 2002-09-03 01:49 ]</font>

bosone · Post by **bosone** » Tue Sep 03, 2002 1:58 am

ehi.. wait a minute...
you are saying i can SAVE the CC assignement of a device???
how???
thanks!

at0m · Post by **at0m** » Tue Sep 03, 2002 2:31 am

Load device for the first time.
Save CC# to Remote Preset and save list.

For each time you load the device newly into a project, you'll have to select the Remote Preset. Once the project's saved, the Preset list loads automatically.

If you encounter bugs, please report now, before final 3.1c is out. SFPreport@creamware.de is the adress...