DSP load chart
DSP load chart
Sorry, i'm quite tired now to do a search for this so, where can i find a DSP load chart related to Modular III and Flexor 1.5 modules???
dsp load
Hi,
The numbers on the cwmodular site refering to the dsp load for 96 48 44,1 kHz, as detailed above, but do these numbers refer to percentage load (%) of a particular scope cards? ie 6 sharc card as 14 sharc card?
thanks
The numbers on the cwmodular site refering to the dsp load for 96 48 44,1 kHz, as detailed above, but do these numbers refer to percentage load (%) of a particular scope cards? ie 6 sharc card as 14 sharc card?
thanks
- roy thinnes
- Posts: 651
- Joined: Thu Jan 09, 2003 4:00 pm
- Location: Graz
- Contact:
To calculate the dsp usage, I'm using the following procedure:
I load a project with just the Modular(2 or III) synth, samplerate is 44.1kHz. The dsp load now is [6.5]. When a module is added into the Modular, the dspLoad rises, e.g. let's take a SSBPhaser module: it's [21.40] now. Then this number is typed into a spreadsheet which subtracts the ModularSynth dsp usage [6.5], which makes a dspLoad of [14.90]. Because these values are varying by adding more modules, I'll add another SSBPhaser. The new dspLoad is 33.30. Subtracting [21.40] gives [11.90] for the second module. The third value is calculated accordingly.
I think that's an applicable way for (approximate) dsp usage diagnostics.
ps: of course the dspLoad values are true for all kind of Scope cards. It's just the Sample freq that counts.
I load a project with just the Modular(2 or III) synth, samplerate is 44.1kHz. The dsp load now is [6.5]. When a module is added into the Modular, the dspLoad rises, e.g. let's take a SSBPhaser module: it's [21.40] now. Then this number is typed into a spreadsheet which subtracts the ModularSynth dsp usage [6.5], which makes a dspLoad of [14.90]. Because these values are varying by adding more modules, I'll add another SSBPhaser. The new dspLoad is 33.30. Subtracting [21.40] gives [11.90] for the second module. The third value is calculated accordingly.
I think that's an applicable way for (approximate) dsp usage diagnostics.
ps: of course the dspLoad values are true for all kind of Scope cards. It's just the Sample freq that counts.