xtc latency

mrvinyl · Post by **mrvinyl** » Sun Dec 30, 2001 12:46 pm

im gettin loads of latency using pulsar plugins xtc mode in cubase but my outboards midi instruments have no latency im using a midiman 4x4 for my out board stuff

confusing please help

at0m · Post by **at0m** » Sun Dec 30, 2001 12:56 pm

XTC live instruments or efx cause 2-3 times the latency of regular PulsarOS mode. See also this topic for latency info.

And have a look at your manual.

<font size=-1>[ This Message was edited by: atomic on 2001-12-30 12:57 ]</font>

mrvinyl · Post by **mrvinyl** » Sun Dec 30, 2001 1:41 pm

great thanx for the advice, ive slipped it down to 13ms

but still seems to be loads worse than when i had pulsar v1.3 software installed.

cheers

at0m · Post by **at0m** » Sun Dec 30, 2001 3:00 pm

Did Pulsar OS1.3 allow you select lower latency? I though ULLI was only released with the 2nd gen cards. Wasn't 1.3 for Pulsar1?

Does the 13ms work fine now? 13ms is one-way route time, but with XTC audio goes back and forth between VST host and Pulsar cards. Each go is 13ms.

so an XTC synth with altering genuine VST inserts and XTC inserts can drive latency over 50ms easily. With a 13ms latency driver.

<font size=-1>[ This Message was edited by: atomic on 2001-12-30 15:04 ]</font>

mrvinyl · Post by **mrvinyl** » Sun Dec 30, 2001 3:11 pm

pulsar os 1.3 didnt have ulli
but my midi synth would record midi into cubase no probs no noticeable latency

but now with 3.01 i am having to go into the piano roll and move my parts slightly forward after recording and i never had to when i had 1.3os

but i have changed from win 98 to win xp

regards

Post by **garyb** » Mon Dec 31, 2001 4:43 pm

this is the nature of live vst.just use pulsar mode and this will not be a problem.