Defeater Key without I/O with another soundcard works!

Man-Machine · Post by **Man-Machine** » Fri Jun 10, 2005 9:55 pm

I finally got my Scope project card working as a dedicated dsp card along with another soundcard (well, just about...) I'm running audio from Cubase SX to my Tascam firewire interface ASIO drivers and using Scope plugins like in XTC mode. All I did was install the defeater plug on the board and detach the IO plate out. Next, I selected "no I/O" on the I/O Enabler utility. Without even reinstalling the software I ran Cubase and it asked me for some cdkeys for some of the third party plugins I have and that was it! I haven't tried all the plugins yet but there are some quirks though. Minimax gives you an error warning when you first start it but once you click ok it's all good. My Profit 5 on the other hand does not seem to work. It keeps on giving error messages. Other than these two synths my Protone, Prodyssey, Vectron and a few other synths and fx that I tried seemed to work with no problems. I'm almost there. Now, if I could only get Profit 5 to work...

_________________
L8ter Oscill8ters!

<font size=-1>[ This Message was edited by: Man-Machine on 2005-06-10 22:58 ]</font>

antplugger · Post by **antplugger** » Sun Jun 12, 2005 7:45 pm

Quick Question - Where did you get the defeater key from ?

Thanks
AP

Man-Machine · Post by **Man-Machine** » Mon Jun 13, 2005 8:26 am

You can get it directly from Creamware but I actually had my dealer do that. It only took a couple of days...

antplugger · Post by **antplugger** » Mon Jun 13, 2005 10:45 am

Thanks - Just ordered one from JRR Shop

Cheers

at0m · Post by **at0m** » Mon Jun 13, 2005 8:34 pm

Hey Man-Machine,

There's something similar on my drive too, but this comes with a default install AFAIK: C:SFPAppIOEnablerIOEnabler.exe - is this the 'defeater key' you're talking about? Or is that some registration key?
Cheers,

at0m.

Post by **Guest** » Tue Jun 14, 2005 8:16 am

it is a small plug that connects where the sync plate connects on the pulsar card

Man-Machine · Post by **Man-Machine** » Tue Jun 14, 2005 11:30 am

Yep, it's a hardware black piece and there's only one place it can connect. Now make sure you unscrew and disconnect all the I/Os. The only drawback is that by taking them out I can't find a way to screw the soundcard on the case. It's only hold by the slot on the mobo

at0m · Post by **at0m** » Tue Jun 14, 2005 7:21 pm

Ah, I didn't know that... cheers!

For my SRB there was this dummy backplate, screwed on near the edge. Swapped it round when I changed IO to the SRB from the other deck, keeps the cards from drooping

Anyone happen to have seen one available somewhere?

tripstation · Post by **tripstation** » Fri Jul 15, 2005 5:30 am

Hi,
does this work with 15DSP boards as well,
regards,
Tripstation