Hi all,
plese can someone explane the routing
to pulsar mixer in the project
nuendo v2
Nuendo (by jules)
-
Guest
Subject: Re: Nuendo
Sure, open Pulsar Project and make sure you've got ASIO module included. You can set # of ASIO channels(Right click, I think). Now open Nuendo->Devices->Device setup...->VST Multitrack and make sure that ASIO driver is 'ASIO Scope'. Nuendo will recognize # of channels. When you open Nuendo mixer(F3) on the bottom of every fader you can adjust how you want to route them. So ASIO channels are represented as Buses in Nuendo. I hope that helps, marko
Sure, open Pulsar Project and make sure you've got ASIO module included. You can set # of ASIO channels(Right click, I think). Now open Nuendo->Devices->Device setup...->VST Multitrack and make sure that ASIO driver is 'ASIO Scope'. Nuendo will recognize # of channels. When you open Nuendo mixer(F3) on the bottom of every fader you can adjust how you want to route them. So ASIO channels are represented as Buses in Nuendo. I hope that helps, marko
Subject: Re: Nuendo
jules,
The ASIO source module(signal from Nuendo) will connect to the Mixer inputs and the Rec outputs will connect to ASIO dest(signal to Nuendo). Any ADAT sources go to the "In" on the Big mixer. To hear what's going on, connect Mon Out to the analog dest, then the analog out cables connect to an amplifier. When you double click on the Big mixer module locate each ot the Big mixer displays by selecting them at the top ie "Mixer 1-8" etc. When you see a live signal displayed, click on the monitor button and move the slider to send the signal to "monitor out". Read through the section on the Big mixer in the manual as you're doing this.
Chuck
jules,
The ASIO source module(signal from Nuendo) will connect to the Mixer inputs and the Rec outputs will connect to ASIO dest(signal to Nuendo). Any ADAT sources go to the "In" on the Big mixer. To hear what's going on, connect Mon Out to the analog dest, then the analog out cables connect to an amplifier. When you double click on the Big mixer module locate each ot the Big mixer displays by selecting them at the top ie "Mixer 1-8" etc. When you see a live signal displayed, click on the monitor button and move the slider to send the signal to "monitor out". Read through the section on the Big mixer in the manual as you're doing this.
Chuck