Hi yall,
I've done some re-installing/configuring after a SCSI HD died (I decided to finally abandon my SCSI infrastructure after all these years) and I think there are some configuration files which may need to be changed. I have a series of error messages that pop up when I load Cubase SX that read, can't find 'DeviceHarddisk2DR9.' My SFP 3.1c settings are set to not load XTC devices, yet it's trying to anyway. I also found in my vstpluginsxtc folder an xtc config file which listed the directory path to be to the drive location of the old dead drive. So after updating that to reflect the proper paths, it repeats the same errors. When I cancel out of them I can use Cubase no problem, but christ is banging on the enter key a good 70+ times as it tries to initialize each device irritating! Any other config files I should be looking to for edits?
Thanks in advance,
Sam
-the geeks shall inherit the earth-