Page 1 of 1
Posted: Wed Oct 02, 2002 2:24 am
by Puddin'tate
I have a Luna 2 and a Pulsar 1 and I'm running SFP now, do I uninstall the old software?
Posted: Wed Oct 02, 2002 3:01 am
by samplaire
depends on what was your previous soft - if it was 3.0 you can have it installed along with sfp (but don't try to launch them both at the same time)
Posted: Wed Oct 02, 2002 3:01 am
by garyb
i'd wait a bit,until every old project has been gone thru,just to make sure that you transfer any files or devices that you might need.(that'r not in the new soft)
whew!
Posted: Wed Oct 02, 2002 8:18 am
by marcuspocus
Yes, specificaly, keep the FM One, it doesn't exist no more, keep also your dynamixer + micromixer if you didn't buy the propack, also keep inferno for the same reason, or else, you'll loose them
Posted: Wed Oct 02, 2002 5:31 pm
by Puddin'tate
Well.......I uninstalled the Pulsar3.1 software,but......when I tried to start Cubase the scope-Asio driver would not load! so I had to re install it. Why do we need all that software when SFP is supposed to be all we need?
Posted: Wed Oct 02, 2002 6:01 pm
by marcuspocus
Well, in SFP instalation directory, there is a subfolder called drivers, go and install your drivers! That's all... You unsinstalled Pulsar, but after installing SFP, so it just uninstalled your SFP drivers. They are the same files, that's why (not the same version but same filename).
Posted: Thu Oct 03, 2002 6:21 am
by samplaire
wait a while! Did you uninstall SFP 3.1 or Pulsar 3.0 (you wrote Pulsar 3.1 - it doesn't exist)?. SFP 3.1a is necessary as 3.1c is only an update to it.
Posted: Thu Oct 03, 2002 3:48 pm
by Puddin'tate
I uninstalled Pulsar 3.0, my mistake!