now I have SFP do I dump the old software?

Puddin'tate · Post by **Puddin'tate** » Wed Oct 02, 2002 2:24 am

I have a Luna 2 and a Pulsar 1 and I'm running SFP now, do I uninstall the old software?

samplaire · Post by **samplaire** » Wed Oct 02, 2002 3:01 am

depends on what was your previous soft - if it was 3.0 you can have it installed along with sfp (but don't try to launch them both at the same time)

Post by **garyb** » Wed Oct 02, 2002 3:01 am

i'd wait a bit,until every old project has been gone thru,just to make sure that you transfer any files or devices that you might need.(that'r not in the new soft)

whew!

marcuspocus · Post by **marcuspocus** » Wed Oct 02, 2002 8:18 am

Yes, specificaly, keep the FM One, it doesn't exist no more, keep also your dynamixer + micromixer if you didn't buy the propack, also keep inferno for the same reason, or else, you'll loose them

Puddin'tate · Post by **Puddin'tate** » Wed Oct 02, 2002 5:31 pm

Well.......I uninstalled the Pulsar3.1 software,but......when I tried to start Cubase the scope-Asio driver would not load! so I had to re install it. Why do we need all that software when SFP is supposed to be all we need?

marcuspocus · Post by **marcuspocus** » Wed Oct 02, 2002 6:01 pm

Well, in SFP instalation directory, there is a subfolder called drivers, go and install your drivers! That's all... You unsinstalled Pulsar, but after installing SFP, so it just uninstalled your SFP drivers. They are the same files, that's why (not the same version but same filename).

samplaire · Post by **samplaire** » Thu Oct 03, 2002 6:21 am

wait a while! Did you uninstall SFP 3.1 or Pulsar 3.0 (you wrote Pulsar 3.1 - it doesn't exist)?. SFP 3.1a is necessary as 3.1c is only an update to it.

Puddin'tate · Post by **Puddin'tate** » Thu Oct 03, 2002 3:48 pm

I uninstalled Pulsar 3.0, my mistake!