XTC-mode and MIDI

An area for people to discuss Scope related problems, issues, etc.

Moderators: valis, garyb

Post Reply
fortner
Posts: 41
Joined: Fri Jul 05, 2002 4:00 pm
Location: Hamburg/Germany

Post by fortner »

Hi,

I'm using a PIII 1GHz-system which works fine under W2K and WXP with Cubase 5.1 (SFP 3.1a) and a Luna II with a Pulsar SRB in normal mode. I can use a MIDI-Controller CS-10 (JLCooper) controlling the Cubase mixer and it works fine.

If I'm going to XTC-mode, Cubase works fine, I can access all effects in XTC, but MIDI doesn't work. It's not possible to control Cubase by the JLCooper-device...

I heard about problems with SFP 3.1 and MIDI in XTC-mode - any hints or solutions?

Bye Christian

<font size=-1>[ This Message was edited by: fortner on 2002-07-06 18:53 ]</font>
Top
Ignys
Posts: 10
Joined: Wed Jul 03, 2002 4:00 pm

Post by Ignys »

On 2002-07-06 18:53, fortner wrote:
Hi,

I'm using a PIII 1GHz-system which works fine under W2K and WXP with Cubase 5.1 (SFP 3.1a) and a Luna II with a Pulsar SRB in normal mode. I can use a MIDI-Controller CS-10 (JLCooper) controlling the Cubase mixer and it works fine.

If I'm going to XTC-mode, Cubase works fine, I can access all effects in XTC, but MIDI doesn't work. It's not possible to control Cubase by the JLCooper-device...

I heard about problems with SFP 3.1 and MIDI in XTC-mode - any hints or solutions?

Bye Christian

<font size=-1>[ This Message was edited by: fortner on 2002-07-06 18:53 ]</font>
I've got the same problem too. The thecnics from creamware told me that in xtc mode it's impossible to get all the possibilities than you can obtain in a normal mode.
Top
Post Reply

Return to “Problem Solving”