Ok here goes....
I have a Pulsar II board already installed, and an SRB (15 DSP) on order. The installation manual says that *generally* the card with the most DSP should be the *primary* card in the system, and gives examples of how this is set up.
However, my SRB will not have any I/O....even though it has more DSP chips than the Pulsar II.....
Does it matter if the Pulsar II is the primary card.....it SEEMS like it should be...since it will just be sharing the DSP from the SRB, NOT the I/O.
Does this make sense? I guess what I am asking is.....Which card should go in first (i.e. the one farthest "left"...the Pulsar II or the SRB???
Thanks for the answer in advance guys...the manual is a little sketchy on this configuration.....
Cheers