Page 1 of 1
Posted: Wed May 22, 2002 2:03 pm
by Puddin'tate
I was wonderin,what are the best settings with a Matrox g550 and a Pulsar? When I have major tracks in Cubase running I get a crackle when I move the mouse pointer, to and in, my second display containing my Project.No IRQS are shared at the moment.
Epox 8kta3
Pulsar 1
Luna 2
Lynksis ethernet card
512 mb ram
80 gb Maxor
Posted: Wed May 22, 2002 2:18 pm
by at0m
Quickest checks:
Set display to 16bit,
Disable BusMastering, I go via Display Properties -> Settings -> Select PRimary monitor -> Advanced -> Options -> Restart.
Posted: Wed May 22, 2002 6:45 pm
by Puddin'tate
Thanks!Anyone know the best BIOS settings?AGP appature,ect?
Posted: Thu May 23, 2002 1:56 am
by Puddin'tate
I figured out what it was,I re adjusted my ULLI settings.Looks like I'll have to go with 7ms.
Posted: Thu May 23, 2002 4:46 am
by krizrox
Apparently, I have the same problem with my G450 (AGP) card. If you find a fix, let me know. I've tried everything. Next step - replace the card.
Oops - sorry - should have read your message a little closer. You fixed the problem with a latency setting? Mine is set as high as it goes (I don't think tripleDAT supports anything lower).
<font size=-1>[ This Message was edited by: krizrox on 2002-05-23 05:47 ]</font>
Posted: Thu May 23, 2002 5:04 am
by at0m
Try going to lower screen resolutions, ie. 800x600 instead of 1280x1240 or something.
In the BIOS, disable BIOS and Video Caches. These eat your (L2?) cache and are not advised.