Pulsar 2, Pre-sets. Anyone got any good setups. Full set up

WayneSim · Post by **WayneSim** » Mon Apr 22, 2002 8:27 pm

Has anyone got some good set-ups. Pre-sets that they load before recording anything. Or setting up anything. I was hoping someone would have a set-up that enables recording and playback at the same time through my speakers. Basically I would record a drum patteren, then keep recording different tracks over and over, until finally I end up with a big arrangment that I've played everything on. Inculding Midi and Audio all in sync. I currently use Cubase 5. Is all this stuff possible becasue I want to be able to hear what i'm playing back and what I'm currently recording. Plus playing back midi track through a sampler (Akai 2000sp, 3000sp).

I hope someone can help.
Also is there any sites take have some mixer and studio set-up presets for the pulsar 2. Thanks

EarlyFirst · Post by **EarlyFirst** » Mon Apr 22, 2002 11:01 pm

check the project uploads..
Also at this time if anyone needs help with routing (if you can describe it I can route it )

WayneSim · Post by **WayneSim** » Mon Apr 22, 2002 11:56 pm

ok, I need help with routing if no-one has any good set-ups.

1. First I play a midi drum track in Cubase, then play it through a creamware sampler.
2. Then I record the Drum samples to Audio in Cubase.
3. Then I Plug a guitar amp into the inputs of the Pulsar 2.
4. Then I want to record the Guitar in Cubase while hearing the Drum samples (or wav file now) It must be in sync.
5. Then I want to record a second Guitar while playing back the drums and first Guitar.

You can see where I'm going. I've tried this and I keep getting feedback somewhere Becasue the ASIO Souce evently runs through the ASIO Dest and back though the system again when I record and playback at the same time.

I just want to be able to hear everything being recorded and played back without any problems. Then also I want to deal with midi sounds. Sorry to just keep typing but i'm kind of fustrated.

EarlyFirst · Post by **EarlyFirst** » Tue Apr 23, 2002 12:31 am

I put a project up _which_ should not feedback....Unless you change the adat settings...( your problem I think is source_what your recording_ and dest_recorded tracks_) are not separated in the mixer)

EarlyFirst · Post by **EarlyFirst** » Tue Apr 23, 2002 12:32 am

Ok how is the guitar connected?
Analog?

I'll revise the project hold on..
and STS 2or3000?

WayneSim · Post by **WayneSim** » Tue Apr 23, 2002 1:33 am

yes, The Guitar is Analong pluged in to stereo input on the Pulsar 2.
2000 or 3000, does it make a huge difference.

<font size=-1>[ This Message was edited by: WayneSim on 2002-04-23 02:35 ]</font>

EarlyFirst · Post by **EarlyFirst** » Tue Apr 23, 2002 10:10 am

So did the project work for you?
again you can find it in the projects forum...

WayneSim · Post by **WayneSim** » Tue Apr 23, 2002 8:36 pm

Thanks EarlyFirst,
I didn't even know that the Projects forum had user presets. I thought it was a place to talk about what projects you are involed in the moment. How wrong I was. Silly me.

I'm sure everything will work now that I downloaded a few different presets to try out.

Thanks again.