Page 1 of 1
Posted: Wed Apr 10, 2002 11:14 pm
by dblbass
I have two CW cards, and set MIDI ports to 2 in Properties page in dev mngr (XP) for each card. Pulsar lets me bring two Sequencer MIDI Source/Dest pairs into Pulsar window, no prob.
But Logic only sees the first Pulsar MIDI port. Can't find any settings in XP, Pulsar, of Logic which will solve this. shouldn't I be able to see two MDID ports to Pulsar in Logic?
Pulsar and Logic manuals haven't shed any light.
Posted: Thu Apr 11, 2002 8:47 am
by Zer
you have to create a new instrument in logic and to define it to your needs using either the add new track replace with new instrument function in the menu or palce a new environment.
Posted: Fri Apr 12, 2002 12:46 am
by dblbass
Thnx, but I know that.
My problem is below that level. Logic doesn't display a second MIDI Pulsar port in the drop down for direct assignment in any instrument parameter window, nor in the port assignment drop down for virtual MIDI out ports I create in the environment.
It is as though windows XP is only exposing one Pulsar MIDI port to Logic. Shouldn't I be able to get more here?
Where to adjust settings? XP, Logic, or Pulsar?
Posted: Fri Apr 12, 2002 1:27 pm
by kimgr
Check your win.ini [logic] settings.
What version of Logic are you using ?
Kim.
<font size=-1>[ This Message was edited by: kimgr on 2002-04-12 14:28 ]</font>
Posted: Fri Apr 12, 2002 7:33 pm
by dblbass
tkx alot Kimgr, that did the trick. I knew it was in there somewhere.
win.ini had lines for Pulsar_MIDI_Out_2 and Pulsar_MIDI_In_2, but both were set =0. I changed them to be the same as ..._1, and everything works now as it should.
thanks again
BTW I am currently using 4.8.1 LAP. 5.0 is "in the mail" according to my unreliable vendor. The above fix seems a bit clumsy. I would think Logic would expose this as a user setting, even it it requires a forced re-boot to be enabled. Does Logic 5.0 handle this better?
anyway, thanks