sound forge integration
hi, i'm a happy new pulsar user but i can't seem to get sound forge to see the record input that i'm feeding it from my board(03D with ADAT out). i've tried reconfiguring the pulsar wave source and dest and have managed to route the output of sound forge to a pair of adat outs but can't seem to get the input to it. any help on this would be great. thanks, igbw
Do you get sound from the 03D at the ADAT inputs of your Pulsar?
If so, just route from 'ADAT source' inside pulsar to 'Wave destination' -- if you have a couple wave destinations, be sure to choose the correct one in Soundforge's preferences.
If you don't have any sounds coming from the ADAT inputs from your 03d - be sure you're sending them properly from the 03d - generally setup the aux or bus (in my case, I'm using all aux/bus to Pulsar for 8 channels from the mixer into Pulsar) (as a side note, the analog Aux sends still work even with digital connections so you can ALSO send stuff to rack equipment!). on The YGDAI Output page (ADAT output) of the mixer, be sure there are levels jumping.
If so, just route from 'ADAT source' inside pulsar to 'Wave destination' -- if you have a couple wave destinations, be sure to choose the correct one in Soundforge's preferences.
If you don't have any sounds coming from the ADAT inputs from your 03d - be sure you're sending them properly from the 03d - generally setup the aux or bus (in my case, I'm using all aux/bus to Pulsar for 8 channels from the mixer into Pulsar) (as a side note, the analog Aux sends still work even with digital connections so you can ALSO send stuff to rack equipment!). on The YGDAI Output page (ADAT output) of the mixer, be sure there are levels jumping.