Asio in Scope 7 w/ win11 & ableton 10.1.25

[dynamixii]

Does ASIO work with the new scope 7?

I'd like to route the analog ins from my A16 and the Ferrofish a16 into the adat ins on the 2 pulsar cards?

I added the 2 ADAT sources, then added asio 32 destination and added a bunch of channels then routed the pulsar 2 ADAT source to the asio destination.

Then went to ableton 10.1.25 and tried to enable the asio scope but it says it failed to open the asio scope

Any help is greatly appreciated


D

[garyb]

Ableton in win8 compatibilty mode.

[dynamixii]

Went to actual app in the pep folder and right clicked and changed to win8 compatibility.
Tried that with no luck.

[dynamixii]

Does scope 7 have to be in any compatibility or run as admin ?

[valis]

Scope 7 will be set for Admin by default, but should not be set to any compatibility mode.

Ableton's shortcut should be set to compatibility for Win 8.1

[dynamixii]

Did that still no luck..

[valis]

Does Scope prompt for elevated privs when launching?
Try the ASIO2-32 Source 64 & ASIO2 Dest-64 pairs, set them to 2-4 channels each.
Did you enable the selected i/o's from Ableton's panel?

[dynamixii]

It works now thanks to Gary's suggestion to use the asio 2