XITE-1 DSP Structure.pdf
Inferman wrote:No more SAT connections from DSP 11 to DSP 5
Start building your project new.
Don´t use STM1632X mixer,- use STM2448X instead,- not all devices in SCOPE 5 / 5.1 are fully optimized for XITE units, so we have to wait for SCOPE 6 improvements.
1.)
Select default or NEW project w/ minimum configuration of hardware I/Os and basic MIDI and load.
Remove STM1632X mixer if it´s in that project already.
Save as p.ex. "my new project" and reload.
2.)
w/ auto DSP assignment load STM2448X
3.)
do the desired connections from SCOPE project hardware I/Os (ADAT / analog) and ASIO to STM2448X
4.)
If you need aux FX connected to STM2448X, load w/ auto DSP assignment and connect
5.)
Place VDAT(s) manually on DSP #2
(right clicking the VDAT devices after loading these into the project window, there´s a pulldown menue you can choose the DSP from)
Save project w/ new name, re-load and see if that works.
If not, start all new by selecting and loading your "my new project" file and swap 4.) and 5.),- means load the VDAT(s) before you load the aux FX (I can´t remember what I did 1st,- the aux FX or the VDAT).
It should be possible to run up to 3 VDAT on DSP #2.
Save the project under new name, p. ex. "my VDAT_ASIO" and re-load.
That´s how it works for me w/ Win XP Pro SP3 32Bit.
If you´re using Win 7, make sure you run SCOPE in administrator mode.
If you are on Win 64Bit, I have no clue,- 32Bit only here.
Read attached file (quote from Ralf)
good luck
Bud