Quick advice needed on 3 cards and stdm cable
Posted: Sat Oct 15, 2011 12:51 pm
Hi all
I have 2 Lunas, and a SRB. I have lost the hardware install manual and it is not anywhere in pdf.
I assume one cable between all 3, is that correct.
Where should the cable go, to the SRB, there are 2 possibilities, forward most (near I/O) or rear (Luna connecter is at mid point).
I recall I install hardware, windows finds them, then install from the scope 4.0 folder I have (4.5 never worked).
Thanks
Geoff
I have 2 Lunas, and a SRB. I have lost the hardware install manual and it is not anywhere in pdf.
I assume one cable between all 3, is that correct.
Where should the cable go, to the SRB, there are 2 possibilities, forward most (near I/O) or rear (Luna connecter is at mid point).
I recall I install hardware, windows finds them, then install from the scope 4.0 folder I have (4.5 never worked).
Thanks
Geoff