optimaster crashes scope when modifying normalizer

[ARCADIOS]

i have seen this for first time.
in fact i have loded optimaster in the master mix section of stm2448 in a multi fxS module.
i have the project with optimaster loaded by default . multi fxS(orange button)_is turned off by default to save dsp power. when i press something in optimasters section of normalize then scope crashes....."scope needs to shutdown"
helplease!!

actually i see it happening when pressing the snap or continious button of the display info of the normalizer!!!

i see that it does not happen if i load optimaster straight at the mix inserts. it happens when i load it into the multiFxS insert that is loaded(the multiFxS) into the
mix inserts!!!

[ARCADIOS]

i notice that multiFxS turn Off (orange when On) device releases more dsp power than when turning Off Mix(STM2448)inserts (green when On)....

[ehasting]

i see the same.. any new version out maybe?
But.. thanks for the "tip" regarding loading it directly into the insert..
i thought the bug was an overall bug!