Sorry for bringing up the problem again, but I still get MME errors when I try to load HDrecording software besides a MIDI application and the Pulsar. I've tried every hint posted (thanx 4 dat!), but to no avail.
Any Pulsar Geek / Totally Obsessed Pulsar Geek outthere that can tell me what's wrong?
I think you'll need to load up another Wave Source and Wave Destination module, as your sequencer is probably grabbing and holding tightly to "Wave Source 1" and "Wave Dest 1"
I think there is even a 16 Wave Source module and 16 Wave Destination device in the same device folder. You will of course have to configure the program to use these specific Wave Source/Wave Dest modules.
You may have to raise the maximum allowable number of modules in the Driver Properties, here's how: Winkey+Pause, Device Manager, click on Pulsar, click Properties, and Wave devices will be an option, raise it to at least 2, I think you can have up to 16. You will probably have to reboot for the change to take effect -- and you only have to do this once!
Remember to drag in an appropriate Wave Source/Wave Dest module and wire it up afterwords. You might even want to save your default project with extra wave modules in there too.
