Adding Smux connection to scope ?

[mozizo]

hi all.
I work at a studio that uses 2 scope boards.
on the first card there is a "plus" extansion plate which support up to 8 Smux Chanels.
on the 2nd card theres a 3 in and 3 out Adat optical port extansion .
the problem is that i cant find a Smux module for that Adat extantion(for the second scope Board).
we record only at 96 khz and i cant use those adat ports for 96khz.
in the menu of the Hardwere IO there is only Adat module for the 2nd Board, no Smux.
is there any way to add smux module for that Adat ports or its should be bulit in the Adat Extantion and i have to replace them to somthing else ?
thanks.

[mozizo]

hi again.
the 2nd scope board as C-plate to it.
it should support Smux?

[Fluxpod]

About the second card.I think that the 3 adat pair cards are the really old scope sp boards.Its possible they dont support smux.Not sure about this tho.
I doubt another plate wil fix this but maybe someone else can clear that up.

[kylie]

classic plates should do s/mux as well. I know that the ADAT24 plate is somewhat older and not available anymore, but the documentation says there are I/O modules called S-Mux C Dest / Src that are only availabe with the ADAT24 plate (A + B for C and P plates, and A only for Z-Link), so I would assume that it should work. there is a line saying "only with pulsar2 or current scope hardware", so maybe your dsp board just does not support it...

[mozizo]

well in the application folder where the IO modules are i didnt see any Smux module for C-plate only 3 adat src/dest modules.
but there is 3 Smux modules for c-plate2 which i dont know what plate is it.
is it still avilabile to buy ?
well if no sulotion ill try to convince the studio woner to record at 44.1 or change buissnes to bakery if possible

[kylie]

c-plate is a classic plate (unbalanced analog and spdif).