No sound Windows xp doesnt recognise it

hamnet · Post by **hamnet** » Sun Apr 20, 2008 4:51 am

Hello i just installed luna 2 with scope 4.5 on windows xp service pack 2 and after the reboot of the installation my music player cant find a soundcard. Windows xp does recognice it but i hear no system sounds.

FrancisHarmany · Post by **FrancisHarmany** » Sun Apr 20, 2008 5:12 am

Drivers installed propperly ?

What audio playback device is windows configured to use ? ( control panel > audio devices )

hamnet · Post by **hamnet** » Sun Apr 20, 2008 5:16 am

thanks for replying so quickly i just rebooted again and noticed i must run scope 4 to let play winamp (i see movement in the program) but still i hear no sound. in control panel it uses creamware play/rec 1

FrancisHarmany · Post by **FrancisHarmany** » Sun Apr 20, 2008 5:24 am

Ok so you see the mixer activity when winamp plays ?

You can check to which hardware-outputs your mixer is routed. Have you see the routing window ?

hamnet · Post by **hamnet** » Sun Apr 20, 2008 5:29 am

in the scope platform you mean? i see in the menu of OUTs:

MIDI 1
SEQ 1
WAV 2
WAV 2
AUDIO 2
AUDIO 3
ASIO 2

FrancisHarmany · Post by **FrancisHarmany** » Sun Apr 20, 2008 5:34 am

hmmmm..... I dont know about these "Audio" things, but on my pulsar2 & scope I have "analog dest" which I use.......

Tau · Post by **Tau** » Sun Apr 20, 2008 7:51 am

hamnet wrote:in the scope platform you mean? i see in the menu of OUTs:

MIDI 1
SEQ 1
WAV 2
WAV 2
AUDIO 2
AUDIO 3
ASIO 2

Those are on the live bar, it's a list of the loaded output (=dest) modules, and not what Francis was talking about... You should go to the routing window, load a "wave 24 bit source" module (appears as WAV on the INPUTS menu), and that will bring in the sound of the Windows driver into the scope environment.

You should then connect that module to the physical output you're using to listen, either directly, or through a mixer.

Hope this helps

Good luck!

T

hamnet · Post by **hamnet** » Sun Apr 20, 2008 9:21 am

hi i have put in the 24 wave bit source (3) into the routing window my question now is how do i connect it onto the physical output ? it connected automaticly onto IL6, IR6 dont know what it means. many thanks for replying!!

hamnet · Post by **hamnet** » Sun Apr 20, 2008 9:44 am

i just want sound from my pc winamp is a part of it

Mr Arkadin · Post by **Mr Arkadin** » Sun Apr 20, 2008 12:17 pm

Drag 'n' drop a Wave Source module into the Scope Project window. Drag 'n' drop the Analog Dest module. Connect the outputs of the Wave Source to the inputs of the Analog Dest. Open up you windows player - you should hear something now. Save this project as your Start Up Project if you want it on boot up (Set>Settings>Projects>Save Project as Startup.