routing scope synths into cubase

judiefre1 · Post by **judiefre1** » Sun Sep 09, 2007 6:41 am

hello im new to scope and am having problems recording scope synths in cubase. please describe exactly how to route my devices. ive tryed numerous configurations and am able to record a midi track and hear it play back but when i export a audio mixdown it comes flatline with no audio

JoeKa · Post by **JoeKa** » Sun Sep 09, 2007 7:19 am

the synths in scope are handled like external hardware, you have to record them to tracks, exporting works only with VST plugs. I don't know if running the XTC mode will allow exporting Scope generated sound, because I never used the xtc mode.
So, just route your scope synth outputs to asio destinations, and you will be able to record and mix them in cubase.

judiefre1 · Post by **judiefre1** » Sun Sep 09, 2007 9:24 am

thanks so much this deff. cleared things up for me

judiefre1 · Post by **judiefre1** » Sun Sep 09, 2007 9:45 am

actually sorry i just tryed sorting it out and faileed

do i connect scope midi source to sequencer midi detination and leave midi destination free? and the outs of the synth directly to asio destination or through the mixer and then out a bus? last question where exactly do i find these inputs u were describing on cubase? vst connections? sorry for all the questions just want to keep the little hair thats left on my head attached. thanks

judiefre1 · Post by **judiefre1** » Sun Sep 09, 2007 11:58 am

sorry im still not getting any sound for some reason. heres a screen shot so u can see whats wrong. btw all my equipment is connected to scope card not luna, thanks again stardust

judiefre1 · Post by **judiefre1** » Sun Sep 09, 2007 12:03 pm

what i did was add another bus to the vst input

judiefre1 · Post by **judiefre1** » Sun Sep 09, 2007 1:15 pm

it works

thanks so much stardust if i could see u id kiss u