hello, i'm a very new guy in the creamware world, and the fact is that i have some problems!!!!!!!
Well my request and question is that i own a pulsar 2 that wired to my A16 Ultra in Adat Optical and my H8000FW is plugged to the A16 in WordClock Bnc. First of all is this is good?? eheh and can i, and if yes how i, sync my Pulsar and my A16 to the clock of the H8000.
I can't put in cubase the H8000 as asio cause i have not all the output i need to go on my Analog mixer..... I'm on PC.
Thx in advance, please help!!!!!!!!!!!
Syncronisation Pulsar II - A16 Ultra - H8000FW
sync is for digital info. once the signal is analog again, there's no need for sync, so whether or not all three need to be synced depends on whether they are all connected digitally or not. the bnc connection is only for transfering sync, not audio, so if you connect the h8000 to the a16 bnc, you'll need to set the a16 to bnc slave and scope to adat slave.
at any rate, you will not be able to use the i/o on the h8000, as the computer can only use one asio source at a time.
at any rate, you will not be able to use the i/o on the h8000, as the computer can only use one asio source at a time.