Pulsar 1 cable unbalanced/SPDIF
Posted: Tue Jun 12, 2007 4:46 am
Does anyone know the pin assignment of the Pulsar 1 breakout cable (unbalanced/SPDIF)???? Can´t find out by measurement, because I lost the cable....
cheers, Tomastroman wrote:well, it's not that difficult - just multimetered one of mine
if you look from the soldering side of the connector (from behind), then
the bottom row is not connected
top row from left to right (9 to 1)
analog in L, in R, out L, out R, dig in, dig out, midi through R, out R, in R
middle row 3 rightmost (12 to 10)
midi through L, out L, in L
all ground lines to the shield of the connector
the L and R in midi mean the left and right pin beneath the middle one, if seen from behind
happy soldering, Tom
...you'll know why that thing costs 50 Euro afterwards
<font>[ This Message was edited by: astroman on 2006-03-27 16:56 ]</font>
