urgent !!!!

renaud · Post by **renaud** » Fri Feb 23, 2007 4:41 am

I all ,

i have used a luna + adat expansion together with a pulsar 1 with 4dsp.

i also have a sync plate ; the cards are slaved via bnc to my converters .

recently i had a problem with the pulsar getting wierd sonics on the adat inputs . i double checked everything and finally tried a friends
scope card in place of it with success. strange .

i have another luna in spare .

My question is : do i need one syncplate per card or can i run ok

with 2 luna's each with an adat expansion and one syncplate for the 2 cards ???

thanks guys

astroman · Post by **astroman** » Fri Feb 23, 2007 4:47 am

one syncplate per system - otherwise BNC sync wouldn't make much sense, wouldn't it ?

cheers, Tom

renaud · Post by **renaud** » Fri Feb 23, 2007 4:49 am

thanks Tom

is it possible i have to send back the card to creamware to buy an adat extension or can i buy it online ?

Herr Voigt · Post by **Herr Voigt** » Fri Feb 23, 2007 3:27 pm

I bought my ADAT extension online. You'll be able to add it to your Luna card, it is really very easy..
Good luck, Thomas

kylie · Post by **kylie** » Thu Mar 01, 2007 6:20 am

Herr Voigt wrote:I bought my ADAT extension online. You'll be able to add it to your Luna card, it is really very easy..
Good luck, Thomas

hi thomas,

when did you buy it? if recently, would you be so kind to tell me the hardware revision that is printed on the board? I'm still looking for someone to have an adat expansion running with a scope home board (hw rev 1.4) and a working expansion connected to it...

-greetings, markus-

btw. it would be nice to know if there are other syncplate hw revisions than 1.0.

Herr Voigt · Post by **Herr Voigt** » Thu Mar 01, 2007 11:01 am

Hi Markus,

I bought the extension for my Luna 2 at Thomann in August 2006. 189 EUR.
Plz tell me where the HW revision number is. I bought my Luna 2 already in 2002, perhaps this is useful for you.

Gr, Thomas

kylie · Post by **kylie** » Fri Mar 02, 2007 4:50 am

Herr Voigt wrote: I bought the extension for my Luna 2 at Thomann in August 2006. 189 EUR.

hi thomas,

the hw revision is printed onto the circuit board. if you hold it with the populated side looking at you, and the slotcover to the left, it's in the upper right corner (afair).

the background is (I already asked about that) that I have 2 older cards (a luna and a ps) with pcb rev 1.3 and a newer scope home with hw rev 1.4. together with the latter I can't see the additional ports. my extensions hw rev is also 1.3, so I guess that there could be a newer pcb release that runs with the newer cards. but this is unconfirmed by either cw and/or pz.

everytime somesone mentions that he or she owns an adat expansion I try to get my theory confirmed...
maybe you are the man

-greetings, markus-

ps. sorry, renaud, for hijacking your thread

but you got your answer already, so maybe it's not that bad...