Page 1 of 1
Installer crashing
Posted: Mon Feb 12, 2007 3:18 pm
by craighuddy
Trying to put Scope on a new PC and everytime I run the installer it crashes. It ran once and installed the drivers, after reboot it won't run again. I have uninstalled drivers and retried but it still crashes. I tried 4.0 and it crashes as well. Any ideas?
CH
Posted: Mon Feb 12, 2007 3:25 pm
by craighuddy
Figured it out.
The installer HAS to see a drive "C:"
My new macine had 3 SATA drives starting at "E"
I went into disk admin, named one of them "C"
and the installer ran fine.
CH
Posted: Mon Feb 12, 2007 11:03 pm
by kylie
craighuddy wrote:Figured it out.
The installer HAS to see a drive "C:"
My new macine had 3 SATA drives starting at "E"
damn, really?
maybe you could have plugged in an usb stick while installing, and assigned C: to it... ?!
-greetings, markus-
Posted: Tue Feb 13, 2007 3:15 am
by craighuddy
more than likely,
As long as it sees a C drive, it was happy.
CH
Posted: Tue Feb 13, 2007 3:41 am
by kylie
craighuddy wrote:more than likely,
As long as it sees a C drive, it was happy.
did you reassign the old driveletter afterwards? and if, does scope still run, anyway?
would be interesting...
Posted: Tue Feb 13, 2007 6:17 am
by craighuddy
yeah it seems to work OK, with one exception, but I don't think it's realted.
Scope complains about not finding a DSP file call P-Plate ASIO B. Obviosly the B channel ADAT ports on the Pulsar are not working either.
I will start another thread about that though.