Installer crashing

craighuddy · Post by **craighuddy** » Mon Feb 12, 2007 3:18 pm

Trying to put Scope on a new PC and everytime I run the installer it crashes. It ran once and installed the drivers, after reboot it won't run again. I have uninstalled drivers and retried but it still crashes. I tried 4.0 and it crashes as well. Any ideas?

CH

craighuddy · Post by **craighuddy** » Mon Feb 12, 2007 3:25 pm

Figured it out.
The installer HAS to see a drive "C:"
My new macine had 3 SATA drives starting at "E"

I went into disk admin, named one of them "C"
and the installer ran fine.

CH

kylie · Post by **kylie** » Mon Feb 12, 2007 11:03 pm

craighuddy wrote:Figured it out.
The installer HAS to see a drive "C:"
My new macine had 3 SATA drives starting at "E"

damn, really?

maybe you could have plugged in an usb stick while installing, and assigned C: to it... ?!

-greetings, markus-

craighuddy · Post by **craighuddy** » Tue Feb 13, 2007 3:15 am

more than likely,
As long as it sees a C drive, it was happy.

CH

kylie · Post by **kylie** » Tue Feb 13, 2007 3:41 am

craighuddy wrote:more than likely,
As long as it sees a C drive, it was happy.

did you reassign the old driveletter afterwards? and if, does scope still run, anyway?

would be interesting...

craighuddy · Post by **craighuddy** » Tue Feb 13, 2007 6:17 am

yeah it seems to work OK, with one exception, but I don't think it's realted.

Scope complains about not finding a DSP file call P-Plate ASIO B. Obviosly the B channel ADAT ports on the Pulsar are not working either.

I will start another thread about that though.