Page 1 of 1
Posted: Sat Aug 12, 2006 7:23 am
by Compact
I do not even know how to be, With instruments there are no problems. I clearly do not know as automatize the
buttons of filters in Cubase. how it is done . Thank
<font size=-1>[ This Message was edited by: Register on 2006-08-12 09:14 ]</font>
Posted: Sat Aug 12, 2006 9:33 am
by garyb
in scope mode, this must be done through midi as the scope device is OUTSIDE cubase. right clicking on a knob allows a midi controller# to be assigned to that knob. recording the midi information of that knob's movements into cubase and then playing it back into the device achieves automation.
in xtc mode, the scope device is automated through the track automation in cubase as the device is INSIDE cubase.
others will likely step in and clarify...
Posted: Sun Aug 13, 2006 9:40 am
by Compact
but I so do not guess where in Cubase it registers
Posted: Sun Aug 13, 2006 10:39 am
by garyb
the midi info gets recorded to and played back from a midi track, just like with any other external device.
Posted: Sun Aug 13, 2006 11:37 am
by Compact
can be we each other of not understend.
I have in conduct the knob and slider
of Filters.
Posted: Sun Aug 13, 2006 1:27 pm
by garyb
yes, that's what i',m talking about. if you are using scope devices and want to automate them, it's done through midi.
in xtc mode, you use cubase's track automation.