I cannot supervise Sliders&Knobs Filters in Cubase avto

Compact · Post by **Compact** » Sat Aug 12, 2006 7:23 am

I do not even know how to be, With instruments there are no problems. I clearly do not know as automatize the
buttons of filters in Cubase. how it is done . Thank

<font size=-1>[ This Message was edited by: Register on 2006-08-12 09:14 ]</font>

Post by **garyb** » Sat Aug 12, 2006 9:33 am

in scope mode, this must be done through midi as the scope device is OUTSIDE cubase. right clicking on a knob allows a midi controller# to be assigned to that knob. recording the midi information of that knob's movements into cubase and then playing it back into the device achieves automation.

in xtc mode, the scope device is automated through the track automation in cubase as the device is INSIDE cubase.

others will likely step in and clarify...

Compact · Post by **Compact** » Sun Aug 13, 2006 9:40 am

but I so do not guess where in Cubase it registers

Post by **garyb** » Sun Aug 13, 2006 10:39 am

the midi info gets recorded to and played back from a midi track, just like with any other external device.

Compact · Post by **Compact** » Sun Aug 13, 2006 11:37 am

can be we each other of not understend.

I have in conduct the knob and slider
of Filters.

Post by **garyb** » Sun Aug 13, 2006 1:27 pm

yes, that's what i',m talking about. if you are using scope devices and want to automate them, it's done through midi.

in xtc mode, you use cubase's track automation.