Hello everyone,
I´m using a PC with 3 CW cards under SFP v3.1c, Cubase SX and an Access Virus TI. My problem is that I can not use (I don´t know how to...) both the Virus as an ASIO sound card, and XTC effects and synths within Cubase.
On my PC, the Virus and the CW cards are seen as sound cards, both from the Windows XP Pro system and by Cubase in the ASIO configuration utility.
But, in a Cubase project, when I insert a XTC device, the device is loaded, but no signal come out of the XTC device, and as a consequence the mix is very silent...!
Does anyone have an idea for this (I hope little) problem?!
Best regards
Fred
Config with 2 sound card types / XTC
well, I don't have any of the two, but there can be only one active ASIO device in a sequencer.
In your case it should be Scope Asio to make the card handle audio io in XTC mode.
There must be a way to make the Virus appear as a VSTi, as otherwise the same problem would appear with any Asio card.
The Virus as an Asio soundcard is probably a mode for those without any Asio card - at least that's my guess.
cheers, tom
In your case it should be Scope Asio to make the card handle audio io in XTC mode.
There must be a way to make the Virus appear as a VSTi, as otherwise the same problem would appear with any Asio card.
The Virus as an Asio soundcard is probably a mode for those without any Asio card - at least that's my guess.
cheers, tom
