PlanetZ forums - scopeusers.com

hi all,

I'm not a newbie here, I've tried everything, I've owned it since 2001, and I changed it from on machine to another in the past 5 years. On saturday I started my computer, realised that the Scope Icon had turned white, started it, but it wouldn't start, so I rebooted the machine,
after start up, samething, that's when I decide to uninstall it, after a new installation of scope I experience de same thing, don't what happened to it, is my card dead ? Is the software desconfigured ?
I have the latest drivers,

help will be welcomed before addressing the issue to creamware,

regards,

Hi, check that the card hasn't become de-seated from the pci slot. To do that, switch off power to the tower & disconnect (unplug) the power cord, then simply ease the CW card out of the pci slot just a little & push it firmly back into place (this can be done with I/O cables still attached to the back)

Doing this may well solve your problem, as even just a little knock or bump can sometimes loosen a pci card.

hi,

thanks for your reply, I've solve it by installing version 3b then v4, fixed and back on the road again,

cheers,

Cool

so basically you have two versions of scope on the same computer?

hi,
I have three lunas boards shipped with differents version ofcourse, as I did not buy them at the same time, but the latest board shipped with version 4 , therefore it was the host for all boards. As version 4 would not launch, had to uninstall them in order to make a new installation. I started installing a board with version 3c, then version 4, voilà !!!

cheers,