My Scope won't respond

dubcotics · Post by **dubcotics** » Mon Jul 10, 2006 12:56 am

hi all,

I'm not a newbie here, I've tried everything, I've owned it since 2001, and I changed it from on machine to another in the past 5 years. On saturday I started my computer, realised that the Scope Icon had turned white, started it, but it wouldn't start, so I rebooted the machine,
after start up, samething, that's when I decide to uninstall it, after a new installation of scope I experience de same thing, don't what happened to it, is my card dead ? Is the software desconfigured ?
I have the latest drivers,

help will be welcomed before addressing the issue to creamware,

regards,

Shroomz~> · Post by **Shroomz~>** » Mon Jul 10, 2006 1:15 am

Hi, check that the card hasn't become de-seated from the pci slot. To do that, switch off power to the tower & disconnect (unplug) the power cord, then simply ease the CW card out of the pci slot just a little & push it firmly back into place (this can be done with I/O cables still attached to the back)

Doing this may well solve your problem, as even just a little knock or bump can sometimes loosen a pci card.

dubcotics · Post by **dubcotics** » Mon Jul 10, 2006 2:58 pm

hi,

thanks for your reply, I've solve it by installing version 3b then v4, fixed and back on the road again,

cheers,

Shroomz~> · Post by **Shroomz~>** » Tue Jul 11, 2006 12:51 am

Cool

H-Rave · Post by **H-Rave** » Tue Jul 11, 2006 8:27 am

so basically you have two versions of scope on the same computer?

dubcotics · Post by **dubcotics** » Tue Jul 11, 2006 1:28 pm

hi,
I have three lunas boards shipped with differents version ofcourse, as I did not buy them at the same time, but the latest board shipped with version 4 , therefore it was the host for all boards. As version 4 would not launch, had to uninstall them in order to make a new installation. I started installing a board with version 3c, then version 4, voilà !!!

cheers,