PlanetZ forums - scopeusers.com

Hi
Is possible to change the interface cable? (i have a RCA in/out and i want to buy a Balanced I/O cable)
Where I can buy it.

I have 2 ADA8000 connected via ADAT but Nuendo 3 (Scope 4.5 Asio drive) show, in the ADAT A, only the channels 3 to 8. Why?

Thanks

I don't have a sequencer but I remember something that said asio 1+2 are reserved by default to the main stereo sum.
If you have evenly connected asio1 to adat1, asio2 to adat2 etc then the first 2 (external) connections would be ignored.
Connecting adat1 to asio3 and so on should give you all IO channels - dunno if that can be re-configured in Nuendo.
At least this is not related to balanced/unbalanced connections.

cheers, Tom
btw that box of Rio Caribe Superiore roasted cocoa beans (beneath my monitors) is from your country - delicious

<font size=-1>[ This Message was edited by: astroman on 2006-07-01 12:01 ]</font>

Have you configured Your Vst Connections correctly

only asio connections are visible inside nuendo. to connect them to adat you must use the routing window. in vst connections(within nuendo) you must enable the additional asio i/o if you want to use more than the first 2.

<font size=-1>[ This Message was edited by: garyb on 2006-07-02 00:27 ]</font>

On 2006-07-01 11:19, gufo wrote:
Hi
Is possible to change the interface cable? (i have a RCA in/out and i want to buy a Balanced I/O cable)
Where I can buy it.

Read this