----- Solved ---- Not all XTC-Plugins schown correctly

recognition1 · Post by **recognition1** » Tue May 02, 2006 12:50 pm

I´m installed Scope 4.0 then i started my Cubase 3.1..... . When i use the plugins from the VST-Plugin Dir (XTC Mode) some does schown correctly like Pattern Delay and Delay Stereo.
When i load a other Delay like Dual Delay Cubase opens a windows ,where normally the knob and faders from the loaded Plugin displayed ,but
there is a Blank Box.(no controls displayed)
All Synthesizer work correctly only some FX have this strange Problem.

<font size=-1>[ This Message was edited by: recognition1 on 2006-05-03 13:01 ]</font>

voidar · Post by **voidar** » Tue May 02, 2006 1:04 pm

Look into why these plugins act this way. Where are they located? etc.

You could try to reload them in Cubase too, perhaps.

recognition1 · Post by **recognition1** » Wed May 03, 2006 7:35 am

I´ve installed CubaseSX 2.2 and 3.
I check the scopevst.cfg later.
And then i uninstall Cubase Sx 2.2.(I use only 3 now).
Thanks for the Help.

recognition1 · Post by **recognition1** » Wed May 03, 2006 11:59 am

I have to solved the problem.
The Creamware Installer didn´t copy the all dll in the VstPlugins - Dir so i had to copy it manually to the VstPlugins- Dir.
I Found them in the xSource - dir .(Folder Stereo and Mono).

THANKS TO ALL FOR THE HELP AND THE SUPPORT.