Routing Gigastudio?

Hangee_77 · Post by **Hangee_77** » Fri Apr 14, 2006 2:28 pm

I use the STM2448 routing the Nuendo & Gigastudio.
I mix the Nuendo2 internally then send the mix output to STM2448 In 1&2.
I route 22 individual Gigastudio channels to the individual input channels of the STM2448 In 3 to 24, cause I would like to mix the Gigastudio in the STM2448.
How to route the outputs so that I can record back my final mixing to Nuendo2 including monitoring?
Thanks.

dawman · Post by **dawman** » Fri Apr 14, 2006 6:53 pm

Are u using GS3?

H-Rave · Post by **H-Rave** » Fri Apr 14, 2006 7:04 pm

I suppose you route all your gigastudio channels onto one stm2448 bus and then into an asio dest,which has been added onto your existing nuendo in busses.

<font size=-1>[ This Message was edited by: H-Rave on 2006-04-14 20:05 ]</font>

Hangee_77 · Post by **Hangee_77** » Sat Apr 15, 2006 7:19 am

I use Gigastudio160 and here is my settings again:
1. ASIO2 24 Bit Source 1L & 1R to STM2448 In1 & In2
2. GSIF Source 1 - 22 to STM2448 In3 - In24
3. STM2448 MixL & MixR to ASIO2 Dest 64 (for recording back to Nuendo2)
4. STM2448 MonL & MonR to Pulsar2 Analog Dest (for monitoring)

All the input settings to STM2448 (#1 & #2)are ok I believe, but #3 & #4 didn't work.
It didn't record anything to Nuendo2 & I couldn't hear anything in my monitor.

hc.

virtualstudio · Post by **virtualstudio** » Sat Apr 15, 2006 2:52 pm

go to settings in giga than to the hardware page and than click all outputs.
set to Scope/pulsar multichannel driver.
this should do it the rest of your routing looks ok
remember to first load scope GSIF sourse driver in to your projectm before starting GigaStudio

<font size=-1>[ This Message was edited by: virtualstudio on 2006-04-15 16:10 ]</font>