How to load SFP in

erminardi · Post by **erminardi** » Mon Apr 03, 2006 6:19 am

Hi, I've forgotten how to load SFP on winXP startup in "reduced tray icon hidden mode" instead normal open mode.
Thanks!

<font size=-1>[ This Message was edited by: erminardi on 2006-04-03 07:19 ]</font>

H-Rave · Post by **H-Rave** » Mon Apr 03, 2006 6:32 am

Make your project with your ins and outs etc.Check it works,Then go into Settings/Projects.Click on save project as startup and tick the active box.Then go into File and click on startup.

<font size=-1>[ This Message was edited by: H-Rave on 2006-04-03 07:33 ]</font>

symbiote · Post by **symbiote** » Mon Apr 03, 2006 9:15 am

You have to start SFP with a "-s" parameter, i.e. "c:SFPbinSFP.exe -s".

at0m · Post by **at0m** » Mon Apr 03, 2006 9:25 am

symbiote, correct, on the condition that the startup project is enabled in SFP's setup too:
""SFP > Set > Projects > ..Startup Project: Active""

After that, i like to remove that auto start line from XP's registry again, you'll find its location with msconfig, then make a line in a .bat file that says ""start /low c:/.../SFP.exe -s"", which i put in Start menu's startup folder, and on the desktop. It makes sure SFP is started in low priority - these mixer's VU's tend to eat quite some CPU eh.