Problems with ASIO, only the right in channel will work ???

Nestor · Post by **Nestor** » Wed Nov 30, 2005 1:19 pm

I’ve had a hard time configuring my system. You always think that new drivers will be better, but this is not always the case. Said that, I go to my problem:

My ASIO Scope does not give me stereo in VSTis, only the right channel will work. I have checked all the cables, it’s not related to the cables. I have changed and mixed different ASIO drivers in Pulsar, but same result. Any instrument you play from SFP is fine, it sounds in stereo, but in VST ASIO transmits only the right channel. What can be causing it, have you any idea? I am quite lost and already truly tired of problems…

Any help will be greatelly appreciated, I have been configuring for too long this time... Cheers

symbiote · Post by **symbiote** » Wed Nov 30, 2005 4:52 pm

And slowly, the reason why Creamware dropped XTC support is dawning on you =P

Post by **garyb** » Wed Nov 30, 2005 5:53 pm

something not installed or configured properly. if the software install was done correctly and the settings are proper, it MUST work.

Nestor · Post by **Nestor** » Thu Dec 01, 2005 7:41 pm

Well, SFP is not to blame here, the problem was caused by a board driver... Fortunately, I can finally say PROBLEM SOLVED! Thank you guys

I'm happy today!

Post by **garyb** » Thu Dec 01, 2005 7:56 pm