Strange STM preset behaviour

Booster · Post by **Booster** » Sat Aug 06, 2005 2:39 am

Saving a Channel Preset in the STM mixer saves the inserts used on that channel too, but with the wrong settings. If the inserts are in the Mutli FX, it loads back emtpy.

Saving a preset from the Main Channel only saves one channel without any inserts instead of the complete mixer.

How can I make a Total Recall for all the channels of my mixer including all the right settings for the inserts?

Booster · Post by **Booster** » Sun Aug 07, 2005 12:39 am

Funny... My STM 1632 mixer can save and restore complete mixer settings, and I remember doing it on a STM 2448 as well. I'm just not able to repeat it. When I restore a preset, only the active channel loads back the stored settings, not the complete mixer.

at0m · Post by **at0m** » Sun Aug 07, 2005 11:12 am

These mixers have different/multiple preset lists, as explained in the manual. Are you taking the right one?

Booster · Post by **Booster** » Sun Aug 07, 2005 11:29 pm

Yes, I know. I was just testing it with the 1632 mixer.

I installed the STM 2448 device again from the Scope CD and I can make new presets again that work like they should. My old presets are not recalled in the right way unfortunately, but at least I can make sound new presets again. Strange though...