What next?

Resonant Serpent · Post by **Resonant Serpent** » Fri May 06, 2005 10:49 pm

Ok. So I finally figured out what all the software, etc. stands for. I installed my card and the scope 4.0 disk. I entered my serials by hand.

I have a link on my desktop that says Scope Platform 4.0. When I click on it, I get a '.exe not found' message.

Did I install it wrong? I looked in the manual, but couldn't find anything on installation. I browsed around and apparently there is supposed to be an icon on my taskbar. It's not there.

I don't know what I've done wrong. Any help would be appreciated. Any links to an installation guide would also be appreciated since I can't seem to find any.

Resonant Serpent · Post by **Resonant Serpent** » Fri May 06, 2005 10:53 pm

I did enter my serials by hand at the prompt for:

Luna Software
Luna Software V3
Main Studiotools Package
Modular V2
SCOPE 4.0 Software

But I couldn't find entries for:

SCOPE Fusion Platform
Volkszdmpler SFP

There was simply not an entry that contained the terminology of either of these entries.

next to nothing · Post by **next to nothing** » Fri May 06, 2005 11:06 pm

On 2005-05-06 23:53, Resonant Serpent wrote:
I did enter my serials by hand at the prompt for:

...
SCOPE 4.0 Software

But I couldn't find entries for:

SCOPE Fusion Platform
...

well there u go.

One thing to try: make sure you installed to default directory (in example c:/Scope).

Resonant Serpent · Post by **Resonant Serpent** » Fri May 06, 2005 11:08 pm

I figured it out

The word 'fusion' threw me off. I put it on the 3.1 and voila!, it works.