Strange msg while loading 2448

[Herr Voigt]

Hello, since I have Scope 4.0, I get the following messages when I try to load the STM 2448:

1. PepDisplayObject: GetGO: Go 'Text' in 'Module Range Text 0dB' not found

2. nil reference on left side of '.' as a result of expression "go Text"

Eyery message appears over 30 x and I have to click on "Ok". Then the 2448 loads, but doesn't function - the aux-effects don't work.

Are there some files corrupt or missing? Should I reinstall the whole software?
Other mixers work properly.

Cheers, Thomas

[fidox]

em ,try to move cw card to other pci slots,
i remember similar message when loading mixer, and i figure out that i didn't place cw cards into right pci slots,
funny but after i remove to other slots it worked just fine ,
also in sfp 4.0


i hope this can be the prob.


matej

[Guest]

try reinstalling that mixer only.

on the CD/4.0 downlod you should have the 2448 as an OXE file

<font size=-1>[ This Message was edited by: antar on 2005-05-06 19:17 ]</font>

[Herr Voigt]

@ antar,

reinstalling with the oxe-file wasn't successful. Nevertheless thank you.

@ fidox,

I thought that I have found the right slots for my 2 cards (IRQ problem was solved), but I'll give it another try.

[Herr Voigt]

So, I changed the slots, but the problem was still present. Now the cards are in the old slots before the problem appeared.
Unfortunately now the IRQ of USB sticks on my Luna card. Every time when I changed my BIOS settings and forced the cards to a new IRQ, the USB-IRQ went with them, like a burdensome neighbour ...
But I need USB - printer, MIDI-interface, masterkeyboard, synth module etc.
Now I made a complete reinstall, and voilà - the STM 2448 works.
Well, let's see how it works

<font size=-1>[ This Message was edited by: Herr Voigt on 2005-05-07 10:12 ]</font>