flexor and V 4.0

nprime · Post by **nprime** » Thu Feb 17, 2005 12:01 pm

http://www.adern.com/products/fleXor_faq.htm

It says here that Flexor is only compatible with version 3.1c, is this an accurate statement?

I am just getting into the MODII and III and I have noticed that everyone here seems to think that I must purchase Flexor. I am running V 4.0 though, so I wanted to check about compatibility.

R

pling · Post by **pling** » Thu Feb 17, 2005 12:35 pm

4.0 works fine. the faq is pre 4.0, it means at least 3.1c.

=>>> go for it!

<font size=-1>[ This Message was edited by: pecora on 2005-02-17 12:39 ]</font>

nprime · Post by **nprime** » Thu Feb 17, 2005 12:38 pm

I suspected as much, but you never know these days...Thanks for the quick reply.

R

pling · Post by **pling** » Thu Feb 17, 2005 12:41 pm

valis · Post by **valis** » Fri Feb 18, 2005 1:53 am

Interesting. If you navigate through the site from adern's home page you should wind up at the current page: http://adern.com/home/modules.php?name= ... view&id=11 rather than http://www.adern.com/products/fleXor_faq.htm (which is part of the old site structure but still in place). I went ahead and updated the old page anyway.