SX 2.0 Cannot load asio scope

Jolly · Post by **Jolly** » Mon Jan 17, 2005 3:52 pm

I use 3.1a software.
I changed the driver settings in SX[device setup][VST multitrack] cos I needed to use the onboard soundcard. When I try to change back to asio scope it says it can´t be loaded. What do I do to load the asio scope?
Sorry I´m a newbie...think and hope there is a simple solution.

Herr Voigt · Post by **Herr Voigt** » Mon Jan 17, 2005 4:12 pm

Maybe rebooting is not necessary.
Close Cubase and startup Scope.
Sometimes an application moves away the ASIO Scope drivers. A simple startup should help. Good luck.

Jolly · Post by **Jolly** » Mon Jan 17, 2005 4:30 pm

Cheers guys - I´ve now tried both but didn´t work!

Wonder what´s going on...any other suggestions?

valis · Post by **valis** » Tue Jan 18, 2005 3:01 am

XTC mode isn't enabled is it?