Page 1 of 1
Posted: Sat Dec 25, 2004 11:09 am
by virtualstudio
I,m used to working with VDAT on my old system, but on the new machine VDAT is causing problems: somtimes it crashes my whole system when I create tape ?????
somtimes it gives error message : your computer is to slow and it doesn't play or record at all.
while the old system is 2.2 ghz and the new is 3.0 ghz
any idea???
Posted: Sat Dec 25, 2004 11:55 am
by marcuspocus
Looks like a disk problem to me.
Are you working on the OS hd? Or on a disk with a sampler that is streaming from it?
Or DMA activated? antivirus trying to scan while the tape create? Anyway, look for similar stuff.
Vdat is working OK here, and was working OK on your older system...So...
Posted: Sat Dec 25, 2004 12:30 pm
by at0m
Yes, strange... any peaks in performance can interrupt playback, comparable to Sonar's stopping when it can't keep up feeding the file stream demands.
I get the 'computer is too slow' on predictable occasions when I do CPU or disk intensitive tasks in Cubase while playing, for example when making the statistics of an audio track.
I used to get the same when a drive had been stopped by power management, but recently VDAT seems to be patient enough for the drive to speed up. I used to work around that by running a task that would wake up the drive beforehand, like browsing or opening a txt on it. Then, during session, power management is switched off of course.
So AFAIK the 'Computer too slow' pop-up shows when VDAT cannot keep up feeding the audio stream. Try running lower bitdepth and/or less tracks, see if that fixes it. If you can't play 8 16bit tracks, something is definately et up or installed wrong.
Also, are you using VDAT in combination with VRC-S or VRC-128? I have sometimes problems with VRC-128, VRC-S seems to make much more stable VDAT.
Prettige feesten!
Posted: Thu Dec 30, 2004 7:45 am
by virtualstudio
I've put a seperate partition to my harddisk for my VDAT tape now.
set the acoustic management off.
still everytime I create a tape, it crashes and the computer restarts.
<font size=-1>[ This Message was edited by: virtualstudio on 2004-12-30 07:46 ]</font>
Posted: Thu Dec 30, 2004 8:07 am
by Immanuel
Creating a seperate partition on the same hard drive does not make the drive work any less. The benefits are probably very small.
Posted: Thu Dec 30, 2004 8:16 am
by Rob van Berkel
@virtualstudio: I've experienced the exact same problems, when I had hyperthreading enabled in BIOS. Disabling solved it for me, without actually noticing the assumed performance degradation.
Cheers,
Rob
Posted: Thu Dec 30, 2004 11:04 am
by virtualstudio
I,ve HT disabled, the Gigastudio does not support HT technology also.
Posted: Fri Dec 31, 2004 8:47 am
by virtualstudio
I've taken two boards out, put the scope in slot 3, started up again and and now I was able to create tape 0n 48 khz not on 96.
then I put my other boards back in: same problem again.
now I,ve put one board in slot 4 and again the same problem.
what to do?? please help!!
after this I put it back in slot 3 and now also same problem ...
<font size=-1>[ This Message was edited by: virtualstudio on 2004-12-31 12:50 ]</font>