Page 1 of 1
Posted: Tue Dec 21, 2004 5:56 pm
by YiannisK
Using nuendo2 as sequencer.
how do you connect a synth so you can use the ext. sync so it automatically syncs with the tempo of the seq.???????
<font size=-1>[ This Message was edited by: Johannis on 2004-12-21 17:57 ]</font>
Posted: Tue Dec 21, 2004 6:45 pm
by nitty gritty
Which synth??
You need to find the parameter (on the synth) that says something like "Sync to external midi clock" or "Ext Sync". This is normally in the "Midi" menu found inside the "Global" menu or the equivalent menu type on your particular synth.
Cheers
Posted: Tue Dec 21, 2004 7:24 pm
by alfonso
you have to set (in Nuendo) Clock messages going out from Nuendo through the Cw Midi port and it will come in Scope from the corresponding Sequencer Midi Source
Posted: Wed Dec 22, 2004 7:09 pm
by YiannisK
Ok so i understand where the connection is for any synth it says inmclk ext. something or other but what specifically do i do in nuendo ??
where do isend a midi time clk from nuendo.
Thanks alot guys for helping me out
Posted: Wed Dec 22, 2004 8:18 pm
by nitty gritty
Not sure with Nuendo but Sx has a synchronisation setup window somewhere in the "transport" menu which configures your midi routing etc... You can also set Sx to "Internal Sync" via the transport bar.
Transport tools are also available by right click on the transport bar.
Hope that does it for you in Nuendo.
Posted: Thu Dec 23, 2004 3:13 am
by YiannisK
Thanks Nitty Gritty for your help i'll try syncing it up hope i figure it out.....
Posted: Thu Dec 23, 2004 4:53 pm
by YiannisK
Hey I got it working and i feel like an idiot. Didn't know you could use the same midi for clk. i guess when you think something is complicated you make it more complicated.
thanks for helping me figure out 1+1=2
douaah.
Posted: Thu Dec 23, 2004 6:59 pm
by hubird
MTC, Midi Time Code...
MidiClock, Midi clock
glad you're in sinc now