Page 1 of 1
Posted: Wed Jun 30, 2004 1:08 pm
by fidox
when i load Z-link A Dest it writes me "Module Appolo I/O-Sys A Dest is not appropriate for your hardware"....
what the hell is this, i never see this message before, i have fresh win install, and everything is installed like before , i have tried to uninstall cards and install it again and uninstall software and tried software version 3.1C and everytime is the same message ???
any tips ?
matej
Posted: Wed Jun 30, 2004 1:16 pm
by blazesboylan
I get this sometimes with my Luna card. Seems to happen to me only with a heavy DSP-usage project, and then only after sitting idle for a long time.
I've always been able to remove all my Luna connections (Z-Link and ADAT), re-insert them into the project. It's a bloody pain because you have to have one finger on the enter button to choose "OK" whenever the message pops up; another finger on the mouse to select your Z-Link module; and another on "Delete".
But with some quick reflexes I've always managed to remove the devices, and re-inserting them doesn't cause problems for me.
Hopefully someone has a more informed answer for you
but in the meantime maybe it's worth trying out?
Cheers + good luck Fidox,
Johann
Posted: Wed Jun 30, 2004 1:33 pm
by fidox
yo,i have luna card and 2496 luna box, i have tried some signal test thru box and i can hear the sound from synth, so there's no sound problem,
i'm sure if i'll re-install win it will be ok, but i don't have time right now to do that again, i did it yesterday already...
well
nevermind, it's worth it for creamware cards
Posted: Thu Jul 01, 2004 3:30 pm
by fidox
i know what was wrong, i was moving pulsar2 xtc to pci slot 2 and that's why there was problem message, i have move pulsar2 back to pci slot 5, where it was at first place and problem disappear...
i think pulsar2 xtc must be installed after luna II card + luna box connected , i mean in pci slot after luna card.....
matej