Z-link problem

fidox · Post by **fidox** » Wed Jun 30, 2004 1:08 pm

when i load Z-link A Dest it writes me "Module Appolo I/O-Sys A Dest is not appropriate for your hardware"....

what the hell is this, i never see this message before, i have fresh win install, and everything is installed like before , i have tried to uninstall cards and install it again and uninstall software and tried software version 3.1C and everytime is the same message ???

any tips ?

matej

blazesboylan · Post by **blazesboylan** » Wed Jun 30, 2004 1:16 pm

I get this sometimes with my Luna card. Seems to happen to me only with a heavy DSP-usage project, and then only after sitting idle for a long time.

I've always been able to remove all my Luna connections (Z-Link and ADAT), re-insert them into the project. It's a bloody pain because you have to have one finger on the enter button to choose "OK" whenever the message pops up; another finger on the mouse to select your Z-Link module; and another on "Delete".

But with some quick reflexes I've always managed to remove the devices, and re-inserting them doesn't cause problems for me.

Hopefully someone has a more informed answer for you

but in the meantime maybe it's worth trying out?

Cheers + good luck Fidox,

Johann

fidox · Post by **fidox** » Wed Jun 30, 2004 1:33 pm

yo,i have luna card and 2496 luna box, i have tried some signal test thru box and i can hear the sound from synth, so there's no sound problem,
i'm sure if i'll re-install win it will be ok, but i don't have time right now to do that again, i did it yesterday already...
well

nevermind, it's worth it for creamware cards

fidox · Post by **fidox** » Thu Jul 01, 2004 3:30 pm

i know what was wrong, i was moving pulsar2 xtc to pci slot 2 and that's why there was problem message, i have move pulsar2 back to pci slot 5, where it was at first place and problem disappear...

i think pulsar2 xtc must be installed after luna II card + luna box connected , i mean in pci slot after luna card.....

matej