I load up XTC project (logic) for FL studio.. Fl appears to recognise the synths and loads them up but stiking a note is like a dirty connection. I can hear the different presets sounds of XTC. When i press stop the noise seems to continue.
<font size=-1>[ This Message was edited by: Ecogen on 2004-05-03 08:42 ]</font>
XTC and fl studio
I tried that too due i'm using FLStudio as Host. I wrote a post in the tech support of FLS and got a short but clear answer: No XTC Support!On 2004-05-03 08:42, Ecogen wrote:
I load up XTC project (logic) for FL studio.. Fl appears to recognise the synths and loads them up but stiking a note is like a dirty connection. I can hear the different presets sounds of XTC. When i press stop the noise seems to continue.
<font size=-1>[ This Message was edited by: Ecogen on 2004-05-03 08:42 ]</font>
The reason is easy. FLStudio don't support different latencytimes of the plugins so the XTC-Plugs cannot be connected to FLS with the correct latencies they would need to work glitchless and in a proper way. Also Image Line didn't planned it in the next time. Your way to use it in FLStudio is via the "classic" way (with the SFP) or getting Cubase/Logic because these hosts are supporting this different latencies. But i recommend you not to use XTC at all because in the SFP mode you have much more flexibility and all your plugins available.
Cheerz,
GenoX
<font size=-1>[ This Message was edited by: genoxcide on 2004-05-03 09:46 ]</font>